Brevard County |
Code of Ordinances |
Chapter 86. ROADS AND BRIDGES |
Article III. DRIVEWAY, UTILITY AND OTHER IMPROVEMENTS |
Division 2. STANDARDS |
§ 86-69. Design and construction requirements.
(a)
All road and easement improvements shall comply to the applicable regulations of the county and state, including, but not limited to, articles VII and VIII of chapter 62, and article II, chapter 22 of this Code, FDOT standards and specifications and exhibits approved by the board of county commissioners.
(b)
The location, manner, installation and adjustment of utilities on county roads shall be performed in accordance with the FDOT utility accommodation guide.
(c)
The edge of the driveway shall be at right angle to the curbline or edge of pavement and shall cross the sidewalk area at the sidewalk grade. There shall be a minimum of five feet, between any driveway and any side property line measured at the property line or at the edge of the paved road surface or curb, not including the driveway flares. Two driveways for a parcel or lot may be permitted if the minimum distance between the two driveway approaches equal or exceeds 30 feet. Driveways shall not interfere with the drainage of the road or adjacent property.
(d)
Maintenance of traffic shall conform with FDOT standards.
(e)
Temporary culverts may be approved for use for access. The minimum size culvert shall be 12 inches in diameter and 20 feet in length. However, a larger diameter culvert may be required.
(Ord. No. 2006-16, § 4, 4-11-06)